Thread: how long should a bit last ?
Threaded View
-
18-12-2014 #2
Last Activity: 29-06-2025
I only use upcuts for pockets so it clears the chips, downcut when I don't want to chip the top edge, parallel for everything else. It's best to rough out using parallel bits then use your 'specials' for a final finishing cut. How long do they last ? good question and something I can't put a figure on. If you use oven cleaner to keep them clean and tickle them with a small diamond stone they last a lot longer.
There's this thread also; http://www.mycncuk.com/threads/6969-...ughing+cuttersLast edited by EddyCurrent; 18-12-2014 at 07:19 PM.
Spelling mistakes are not intentional, I only seem to see them some time after I've posted
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
how long does it take
By i lunn in forum General DiscussionReplies: 2Last Post: 03-12-2014, 03:57 AM -
WANTED: 2 nema 23's 76mm long dual shafts 6.35mm plus one 56mm long nema 23 dual shafgt 6.35
By nobby in forum Items WantedReplies: 0Last Post: 24-09-2014, 09:57 AM -
How long
By Jester in forum General DiscussionReplies: 1Last Post: 04-01-2014, 03:16 PM -
NEW MEMBER: Greetings, Long Beach Ca.
By Mr Bonavita in forum New Member IntroductionsReplies: 1Last Post: 10-09-2010, 01:26 PM -
At Long Last!!
By Wobblybootie in forum DIY Mill Build LogsReplies: 9Last Post: 11-08-2010, 12:58 PM
Bookmarks