Router Modifications to Allow Cutting of Woodworking Joints

[mike os]

that looks useful

[T0rnado69]

ohh bessey clamps....
gotta love em :)

are you planning on some dovetail cutting :)

[EddyCurrent]

are you planning on some dovetail cutting :)

Yes but I bet I can cut them by hand faster.

[JAZZCNC]

Eddy thought that ages ago before building machine it was mentioned about making the gantry go past the end of bed so edge work could be done. Didn't you do this.?
Or have you got another reason for doing it this way.?

[EddyCurrent]

Eddy thought that ages ago before building machine it was mentioned about making the gantry go past the end of bed so edge work could be done. Didn't you do this.?
Or have you got another reason for doing it this way.?

Can't remember seeing that, or thought it wasn't needed, anyway didn't do it. I don't have a big use for this but it was a good little project.

[JAZZCNC]

Yes but I bet I can cut them by hand faster.

Bet you can't to same accurecy and do it repeatably for say 12 draws.!

Regards your fixture Jig do you realise that you can create and save a Fixture offset for this so you don't have to mess around finding Zero.?

[EddyCurrent]

Regards your fixture Jig do you realise that you can create and save a Fixture offset for this so you don't have to mess around finding Zero.?

Yes, plan using G55

[mitchejc]

Great job, looks very nice and its a handy feature to have on a router.

[T0rnado69]

maybe

but i would say, its a bit hard to cut them quickly
with a cuppa in your hand or a cold beer :)

[Ger21]

Yes but I bet I can cut them by hand faster.

Not if you have the right software.
This only took 5 minutes. It would take longer just to lay them out if doing by hand.