DXF or machine problem, or neither !?

[EddyCurrent]

Maybe try it again with the file I just sent, but the toolpaths in your picture look okay so will probably not help.
In CamBam have a look in the Engrave MOP settings, you will see one called 'Velocity Mode'

[Gasgasbones]

Maybe try it again with the file I just sent, but the toolpaths in your picture look okay so will probably not help.
In CamBam have a look in the Engrave MOP settings, you will see one called 'Velocity Mode'

Hi Eddie

Just the same mate :-(

When the Boxford software draws the image before cutting its fine, just like yours. just when it cuts its all angular.

What do I do with velocity mode ? Im new to Cambam and cnc in general so im struggling here.
How can I re-draw it? I can over draw in draft site I believe but I dont know what tools etc to use on the software

Ta

Carl

[EddyCurrent]

Hi Eddie
What do I do with velocity mode ? Im new to Cambam and cnc in general so im struggling here.
Carl

Try both options but make sure your machine is using the same option (if you can change it that is ?)
Have you tried any other CAM software to eliminate that ? although CamBam is a good one.