Text in G-code File

[Web Goblin]

Try using ( ) instead of [ ] and see if that helps.

[Stupoty]

It should probably be,

; I'm a comment
; so am I

i'm not because theirs no semi colon


Edit

(i'm also a comment as i'm in regular brackets)


Linuxcnc have a handy refernce ;)

http://linuxcnc.org/docs/html/gcode/...l#sec:comments
Stuart

[charlieuk]

Cheers I will try swapping them to ( ) and see what happens many thanks

[JAZZCNC]

Charlie It's the [ ] causing problem use ( ) but you'll probably need to modifie the post processor to change this Or some software will have options in the post/G-code output section that let you select how comments are output.

[charlieuk]

cheers yes it sorted the problem, it was in a file that the main code got put in. I have found another move in the main code that it likes to do that I would like to change but Im guessing that is out side of my control other than to manually edit it after. (it is right in the last two lines of coordinates were it moves in a diagonal rather than just up and across out of the block)