Thread: Step 4 Router and Brass
Hybrid View
-
19-01-2015 #1
Last Activity: 02-09-2024
A relativly simple one!!
-
19-01-2015 #2
Last Activity: 19-12-2015
Going for emboss will mean a lot of material removal, in contrast to engraving the letter path only. Also, the whole area removed will show the endmill paths, it is a natural aspect of milled surfaces.
The plate you showed is more suitable to casting, rather then milling. On the opposite side, if the surface was flat and the letter sunk into it, it was more suitable to engraving.
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
RFQ: I need apx 100 brass tubes being cut down
By Chance1234 in forum Projects, Jobs & RequestsReplies: 0Last Post: 02-04-2014, 02:05 PM -
Engraving brass
By Philly in forum Machine DiscussionReplies: 3Last Post: 03-08-2013, 10:09 PM -
3mm sheet brass
By cropwell in forum Marketplace DiscussionReplies: 1Last Post: 17-10-2012, 09:55 AM -
drilling brass?
By irving2008 in forum Metalwork DiscussionReplies: 23Last Post: 04-08-2012, 03:56 PM -
Step 4 router
By John S in forum Milling Machines, Builds & ConversionsReplies: 9Last Post: 11-08-2009, 04:16 PM
Bookmarks