Thanks for the Sketchup suggestion, I have dabbled at it before but ill give it a more focused go now.

I kinda thought that buying parts before design is frowned upon here, but I really didn't have a choice unless have to wait until I Become good in designing software, but I had no patience for that and was eager lol.


Material/Parts so far:

  • 2x HGR 35mm Rail : 1000m & 2 x 35mm Bearing Block, Square
  • 2x 40mm x 80mm T-Slotted Extrusion : 1000m
  • 2x 80mm x 80mm T-Slotted Extrusion : 600m
  • 4x 40mm x 40mm T-Slotted Extrusion : 600m
  • Assorted brackets, nuts and screws for the above
  • 2x 1610 Ballscrew : 900mm & 2x Housing Bracket
  • 2x BK12 & BF2
  • 2x Flexible Coupling Coupler 6.35mmx10mm shaft
  • 2x NEMA 23 Stepper Servo Motor Mount Bracket
  • 4x SY60STH86-3008B Nema 23
  • 1x Leadshine EM806
  • 1x C35S - QUICK SETUP BREAKOUT BOARD (C35S)
  • 1x RPS608 Power supply


Once I get all the items I will lay them out and take photos of how I plan on building and hopefully you guys could contribute on any required adjustments

you would notice I still didn't buy anything for the gantry as I have still not designed it (in my mind lol) and have to procure the side plates which I really need help with.

I'll get more drivers once I configure the first one, would need help with the wiring with the power supply,is it enough to drive 4 of them?

Thanks!