New Build 1000x600x200mm (newbie)

**Clive S** · 23-01-2015

Originally Posted by EddyCurrent

Yes, solder then cover each joint with heatshrink sleeving. Then solder a piece of wire about 200mm long, of the same thickness as the core wires, to the screenm then cover the whole area with a larger piece of heatshrink. Now you should have all the joints covered and that 200mm piece of wire coming out from under the large heatshrink sleeving and that wire is used to earth the screen.

Just for completeness I would suggest 4 core CY 1mm or 1.5mm cable as http://www.csecables.com/acatalog/CY-Cable-4-Core.html .. Clive

**Noplace** · 27-01-2015

Just started learning solidworks, please bare with me I'm a total beginner in this thing but somehow managed to design the frame as I intended based on the parts I bought:

**Noplace** · 29-01-2015

Here is my design of the gantry side plates, the hiwin blocks are actually longer and would be mounted at both ends and not like the design below, I just couldn't find the right CAD model for the HGH35CA

the plates are 10mm thick and they would attach from the bottom outside to the ballscrews ( again sorry I couldn't find the proper CAD models, really new to this and self learning)

Guys I could really use some advise and guidance at this stage, really appreciate it.

Also if anyone is a solidworks expert, I couldn't figure out a way to mate the left and right linears, maybe it will show in the photo that they are not exactly aligned.

**EddyCurrent** · 29-01-2015

If the gantry side plates are aluminium then 20mm thick is the usual advice.

**Blackrat** · 29-01-2015

use parallel mates to hold the bearings on the rails ... then use co-incident mates to hold the 10mm plates onto the bearings
you also use a coincident mate to keep the front faces of the two bearings aligned, so when move the one gantry arm, the other will follow

**Noplace** · 01-02-2015

Updated with 20mm plates and a bit of the gantry, do you think it would need more support or can i stick with just the two 40x40 extrusions?

**njhussey** · 02-02-2015

Hi Noplace, your frame needs a lot of bracing and strengthening as does your gantry. Have a look through some of the build logs and you'll see what I mean....these are two sililar to what I think you're aiming for?

http://www.mycncuk.com/threads/6988-routercnc_MK3

http://www.mycncuk.com/threads/8206-...Axis-CNC-Build