Help! Stepper control board

[Ross77]

9 amp? I Bet the national grid love you. What is that going to control?

It's for steppers 9A max...set for 6 to the N34 motors (Phytron IP54 ones) No experience of Delta Tau...sorry.

No worries, fink im just gunna have to plug it in an hope it dosnt go bang

When are you going to finnish your router then? cant wait to see it working

[John S]

9 amp? I Bet the national grid love you. What is that going to control?

Got some Bosch drivers here 530 volts at 52 amps, do you reckon I can TiG weld with these at 8 metres a minute ? :heehee:

.

[Ross77]

I was hoping to have the router finished this week....other commitments are keeping me busy.....

Tell me about it not enougth days in the week etc.......

Does castration hurt? thats what I'm getting apparently the next speck of silver stuff that hits the axminster....

Depends on the method I suppose, Sharp knife or two rocks :surprised:
So that why your machines look so good, there indoors! mind you if I could get away with it thats where mine would be

[Ross77]

Got some Bosch drivers here 530 volts at 52 amps, do you reckon I can TiG weld with these at 8 metres a minute ? :heehee:

Ok perphaps 9 amp is that much then dont know how to tig weld so cant help im afraid ;o)