Cutting deeper in areas???

[alboy]

Hi Jazz

How are you doing. I haven't tried to cut anything with such a fine text before although I have cut smallish text in a different font which seemed ok but can't say for certain if the problem had been there before, the signs etc I had been doing were fairly big, min 1" text. I had notice a couple of times when cutting templates out of 6mm ply that sometimes it wouldn't cut all the way through in parts but put that down to the material initially. I will check the Z axis coupling again. I reloaded the DSP software just in case but it didn't make any difference. Thought I had another problem as well but it just the tip broke off the V bit Doh. All axis return to home position at the end of a job. If I rerun the job on the same workpiece it does the same, so I suppose it's repeat accuracy is good lol.

Cheers

Alan