First CNC build - VFD wiring question

[Bez]

Cheers for the replies guys :)

Looking through the manual it states its output current at 10A. Its not a fancy VFD just a huflugdung (Huanyeng) special bought from here http://www.cnc4you.co.uk/Spindle/Spi...h-Matching-VFD.

13A plug sounds like a winner to me but I will obviously be careful with other items running on the same ring until I can figure out its own ring for it to sit on.

So looking under the front panel I'm faced with this:



Motor wires are self explanatory so no need to go over those. Where I'm a bit confused is R S T ...... does it matter which one the live and neutral go to? Obviously the earth goes to "9"

I'm using a KK01 breakout board which has a relay output ..... am I correct in thinking this can be used to start and stop the spindle. If so which would be the correct blocks to wire it into from the basic mention in the manual DCM looks like it might be the one but rather than mess things up I'd appreciate any input for people who have run or are running a similar setup.


Thanks again.