Quote Originally Posted by JAZZCNC View Post
How Rude.!!!. . . Did I say a word about the pile of shite.?

The UC100 is ok but it's still USB based and therefore will at some time have same power dropout issues lots of USB based devices encounter. Esp with a Laptop.!

For spindle control thru software you'll need speed control board or BOB that has one built into it. If Chinese machine came with the cheap Nasty DC spindle then chances are it won't have this and speed will be controlled directly from the DC speed controller with a Pot.
If spindle is AC and controlled with VFD then you may have BOB with PWM output so can control speed using this.
Sorry jazz I'm new and before I joined I looked at a few threads in which you always popped up with scathing comments about the Chinese shite as you put it. I know it's not the best but it will do what I want it to do I was on a limited budget.
as for the laptop I went through the power features and disabled them all, the flow of data will probably still be interrupted every so often but the UC100 should cope with that.
the reason for the uc100 as apposed to the various other methods out there is ease of fitting and not wanting to open up the control box.
looks like the spindle is a cheap and nasty DC one but should be a lot better than those on the 3040, I'll live with the spindle being under manual control, if the speed can never be controlled but there is a pin to switch the motor on and off I'll see if I can make up a relay circuit to control the start stop of the spindle.
I have at least got a pot and herz digital readout on the control box I'll learn.
just got a set of diamond shaped cutting bits for the Cnc came from China so there is no knowing the quality, anyone know where I can get better quality bits must be diamond cut 2mm or a bit less I'm cutting carbon fiber up to 5 mm thick.

kendrick