running mach 3 with a usb to parallel adapter

[JAZZCNC]

Thanks, I tried hard to get it to work! Would you buy Mach3 Mach4, or UCCNC Software? I would like to run it unders windows 10 ona newer P.C!
Thanks again for your help!
Tom Megna

My choice would be mach3 because I know it inside out. However, my advice to you would be to go with Uccnc because it's current software that is very good and well supported.
I wouldn't recommend Mach 4 to a new user, or to anyone if I'm honest unless it's changed since the last time I used it as it was so buggy I expected Herbie driving out the back of my PC.