feedrate override using rotary momentary switch?

[routercnc]

Doesn't need to be that hard.? The Pokey's has 7 Analog inputs so just use 0-10V and a POT. Can do the same for Spindle override as well.!

I'd not studied the pokeys system in detail so thank you for that. I assumed it was just a simple keyboard emulator, but obviously not.

As it happens I over-ordered on pots and have a 10k spare one which would be ideal. I have 12v in the control box so I guess I could put a resistor in series with the pot to get 10v across it?

I'd thought about spindle override software control but in the end I decided to run direct manual control using a pot to the VFD. I tend to cut the same things so don't change speed much.

Thanks again