What gauge wire for motors and drivers etc?

[Noplace]

Yes that's exactly what I'm saying and I can't show you photos of one installed in control box but can show pic of how it's done, it's not rocket science.

Just solder Separate wire to shield, fold back and put shrink wrap over then run wire back to Ground point.

Thanks Jazz thats very clear and as I expected, however few more questions if I may:

- What to do in case of using connectors for example like this one http://www.automationtechnologiesinc...h-connector-12 where drivers are connected to patch cable with this connector?
do I ground the patch cable only? the shield on the long cable to motor would be left as is in that case.

- With that cable in your photos how are able to distinguish the 3 black wires from each other??

thanks!