Feed Rates and cutters for wood panels

[JAZZCNC]

If you want to feel insulted go ahead, but don't take offense on behalf of other people.

Did I say anything about insulting other people.!!
" and If I'm honest I for one, having bent over backwards offering sound advice to help find it quite insulting.!"

All I see is rants against chinese machines, with nothing to back it up (Why does that driver 'just about cut it' ? still waiting for that 'help'). And no suggestions (or offer) of alternative machines.

No rants about chinese machines I've always been clear about them.!! They have there place, which is learning, but they are cheap for a reason and that is they use Cheap electronics with cheap components poorly and weakly built. Which means they leave a lot to be desired in actual use. Yes IMO they are Crap.!

Like wise the the Machine you where or are looking at was all mixed up with regards to spec. ie 32mm ballscrews with 3500mm/min rapids. I Told you this on the phone and explained why in some detail.
I also told you I had nothing against Cheap Chinese Manufacturers other than they build to price so something has to give and often IME that is electronics and build quality. I also told you this was learnt from experience upgrading or fixing others machines not just my opinion.

Also just for Clarity for those who know I build machines so may be thinking I told you this to put you off so I could build you one.!!
I was also very clear from the start that I was only telling you this information to help you because I couldn't build you one even if you wanted me to.

Now if offering my phone number and taking time out fo my day isn't helpful then what is.!!

Regards not offering an alternative machines then it's quite simple why.? I didn't because there isn't any company I know in UK or Europe that Could (Or would supply that spec) at that size for $4000 you where being quoted.!! . . . This alone should say something to you.!

Regards me not offering an explination or helping to why those drives are only just cutting the mustard for 6Nm nema 34 motors so worse for larger motors then why the hell would I waste time or offer my hard learnt experience to some arrogant person who doesn't listen.!! . . . . It will be a cold day in hell before I offer any more advise to you sir.

Good Luck.!