Threaded View
-
02-06-2009 #10
FWIW, since 'Jenny from the block' remains totally uncontactable unless you travel on a 300 mile roadtrip to a wheeltappers & shunters fair tucked away in a place that likely isn't recognised by a sat nav, then this guy is selling 4 x flat endmills (3mm shank) for $7.50 delivered to your door...
http://cgi.ebay.co.uk/ws/eBayISAPI.d...m=180354863835
(that works out at about £1.15 per endmill delivered)
(his price is listed a little higher, but if you submit a best offer of $7.50 for two sets (eight end mils in in total, he'll accept - well he did with mine).
Not ball end mills ...but cheap as chips for carbide flat endmills (last price I paid was about a fiver delivered from an Ebay seller in the UK)
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
WANTED: 3mm Ball nose bit please
By Fivetide in forum Items WantedReplies: 6Last Post: 12-12-2012, 05:06 PM -
Simple Solution- Drive 1" Ball Screw Shaft with NEMA-23-Size Stepper Motor Shaft
By LoveLearn in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 08-02-2012, 01:52 AM -
WANTED: ER20/25 straight shank collet chucks
By m_c in forum Items WantedReplies: 4Last Post: 24-10-2011, 12:19 PM -
Leitz Router Bit, Odd Shank Size?
By gazza in forum Tool & Tooling TechnologyReplies: 4Last Post: 27-02-2011, 03:26 PM -
Stepper shaft size and pulley bore size problem
By psiron in forum Linear & Rotary MotionReplies: 13Last Post: 15-06-2010, 04:11 PM
Bookmarks