Thread: 5v power suply
Threaded View
-
30-03-2015 #1
hi all im back again, might seem a bit dumb of me but what would be the best way to get the 5v supply to the breakout board and drivers, i currently have a 5v supply from usb split to 1 b/board and 3 stepper drivers, would this be ok or can u recommend a better way. also i have done a basic mach setup and trial and all i can get the motors to do is turn about half a turn a min evan if i turn up all the velocity etc, im guessing i have done something wrong, please help
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
motor power and chinese spindles power HELP
By DigiSoft in forum Spindles & Drive MotorsReplies: 5Last Post: 17-09-2013, 12:17 AM -
rep power ???
By TrickyCNC in forum General DiscussionReplies: 11Last Post: 19-09-2012, 03:57 PM -
Minimal-cost Power Supply Strategy - Repurpose Laptop Power Supplies
By LoveLearn in forum General ElectronicsReplies: 0Last Post: 25-01-2012, 09:29 PM -
i need more power LOL
By Scott in forum General ElectronicsReplies: 2Last Post: 12-04-2010, 02:41 PM -
Power For Drivers
By SirMorris in forum Motor Drivers & ControllersReplies: 9Last Post: 24-08-2007, 08:53 PM
Bookmarks