5v power suply

[universally]

hi all, i purchased a 5v supply and have it hooked up, its still taking mach 3 well over a min to turn 1 revolution if it bothers to turn at all and has a 8 second delay befor it starts, ive watched numerous videos on the wiring and mach config but its not changing a thing

[universally]

thanks jazz i might have to take you up on the offer, id be more than willing to pay for travel and time :)

[JAZZCNC]

thanks jazz i might have to take you up on the offer, id be more than willing to pay for travel and time :)

I'll PM you my number call me and we'll sort you out one way or the other. Most likely i'll get you going just over the phone but if not then can arrange a visit.

[universally]

[JAZZCNC]

Do you have manual for BOB or link to where you got it.?

[universally]

http://www.ebay.co.uk/itm/3014209437...%3AMEBIDX%3AIT
this is the kit i purchased, all details are on the listing

[universally]

http://www.ebay.co.uk/itm/2011738350...%3AMEBIDX%3AIT
sorry its this 1

[routercnc]

I have this BOB and have just wired it up. Sorry, don't have a photo. Its a DB25-1205. Came free with DQ860MA drivers from Wantai.

5V power on the RH side, step and direction along the bottom, and inputs such as e-stop, limits on the LH side

Wiring is:


Here is Wal's set up: