5v power suply

[JAZZCNC]

thanks jazz i might have to take you up on the offer, id be more than willing to pay for travel and time :)

I'll PM you my number call me and we'll sort you out one way or the other. Most likely i'll get you going just over the phone but if not then can arrange a visit.

[universally]

[JAZZCNC]

Do you have manual for BOB or link to where you got it.?

[universally]

http://www.ebay.co.uk/itm/3014209437...%3AMEBIDX%3AIT
this is the kit i purchased, all details are on the listing

[universally]

http://www.ebay.co.uk/itm/2011738350...%3AMEBIDX%3AIT
sorry its this 1

[routercnc]

I have this BOB and have just wired it up. Sorry, don't have a photo. Its a DB25-1205. Came free with DQ860MA drivers from Wantai.

5V power on the RH side, step and direction along the bottom, and inputs such as e-stop, limits on the LH side

Wiring is:


Here is Wal's set up:

[universally]

great news :] i wired the motors the correct way round (still did not work)
i added enable- wires to the BoB and set pins 1,16, and 17 as the enable- (still did not work)
then i turned on step low active and it worked :) it looks and sounds good to me :)
the only problem i have is that when i tested all 3 motors at once one started to lag, as though there is not enough power for all 3 to be on full motion at the same time, does this sound familiar or maybe something needs tweaking ?