Hiwin Lubrication

[Boyan Silyavski]

Yes, thats the one. That happens, it must come out from somewhere, just make things slowly so you don't damage the seals. The Bearings block is preloaded so its not meant to be judged by hand movement. I just make that from both sides to be sure its full of grease.
Now the thing is that i stopped using nozzles at all. I just needled the side plastic holes both sides and use a small grease gun with conical tip pressed against the plastic. Works like a charm. Easy to rech and grease. No dust could go inside from the small needle hole.