Threaded View
-
12-04-2015 #2
Last Activity: 15-04-2024
Start with the PC side:
-LPT cables- the most likely culprit. had many times problems, check them with multimeter -fine, later problem. basically change the cable to check
-Mach 3 , clean reinstall with the necessary restarts in between
When you are sure that these before work 100% start messing with the board. Check if all outputs inputs work ok. Especially the one that the Estop is wired to. "ENABLE" from software/ emulate/ if works like that its the cable of the Estop. Dont forget to disable that Estop emulation later.
That should be ok for starters.
.
-
The Following User Says Thank You to Boyan Silyavski For This Useful Post:
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Advice needed on Amadeal
By croy in forum General DiscussionReplies: 13Last Post: 21-08-2015, 01:28 PM -
bit of advice needed for first mill
By jmac80 in forum Milling Machines, Builds & ConversionsReplies: 9Last Post: 06-04-2014, 10:59 PM -
First steps, advice needed
By Wobblycogs in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 02-11-2012, 02:30 PM -
Advice needed for Z Design
By Hobgoblin in forum Linear & Rotary MotionReplies: 8Last Post: 10-09-2012, 09:18 PM -
SPG X3 CNC Mill, advice needed please
By shaggyhawkings in forum Milling Machines, Builds & ConversionsReplies: 4Last Post: 07-01-2010, 11:00 PM
Bookmarks