Vectirc question. Bit of G-Code help please

[Clive S]

N90 X0.000 Y0.000 F3600.0
N100 G00 X-27.650 Y-78.650 Z3.000
N110 G01 Z-3.000 F1200.0

line N90 is telling it to go back to the machine Zero with a feed rate of 3600 you can just take out the X0 and the Y0 or change the numbers to some where near your work piece is.
line N100 is taking you at rapid speed to the start of your job and line N110 is dropping your Z down to -3mm at the feed rate of 1200. ..Clive

[Fivetide]

line N90 is telling it to go back to the machine Zero with a feed rate of 3600 you can just take out the X0 and the Y0 or change the numbers to some where near your work piece is.
line N100 is taking you at rapid speed to the start of your job and line N110 is dropping your Z down to -3mm at the feed rate of 1200. ..Clive

Ah ! so if i take out x0 and y0 it will basically just start the work where I set the work piece origin ?
Can I take the entire line out .. -> N90 X0.000 Y0.000 F3600.0 or does it need the feed rate command to function ?

[Clive S]

I would just take out the x and y zero

[Fivetide]

I would just take out the x and y zero

Thanks Clive I will try it tomorrow post results.

[Ger21]

In Aspire or V Carve Pro, you can specify the "home" location, so it goes somewhere else other than 0,0.
You can also edit the post processor to remove that first move.

[Fivetide]

In Aspire or V Carve Pro, you can specify the "home" location, so it goes somewhere else other than 0,0.
You can also edit the post processor to remove that first move.

Hi Ger21 I've managed to reset the machine home to near to the work piece so its working OK now, thanks for the advice