Threaded View
-
19-05-2021 #16
Last Activity: 19-01-2024
Most probably electrical noise on your signal lines. Try adding a little De-bounce which you will find in the General config screen. If this works then you should check out your wiring to make sure signal wires are not running too close to high voltage wires.
Originally Posted by Mikes Planes
-use common sense, if you lack it, there is no software to help that.
Email: [email protected]
Web site: www.jazzcnc.co.uk
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Gecko G540 or?
By JW1977 in forum Gantry/Router Machines & BuildingReplies: 34Last Post: 17-09-2017, 05:28 PM -
FOR SALE: Gecko G540 Controller & Accessories
By jeboa in forum Items For SaleReplies: 3Last Post: 21-09-2013, 09:45 AM -
eBay: New Gecko G540 Controller (Rev 8 With Arctic Silver Mounted Heatsink) $1 No Res 3 Day
By Storm2313 in forum Items On eBay UKReplies: 4Last Post: 08-05-2013, 11:31 AM -
Gecko G540 - local source
By compfranon in forum Motor Drivers & ControllersReplies: 26Last Post: 10-09-2011, 07:06 PM -
Gecko G540
By Sparks in forum Motor Drivers & ControllersReplies: 14Last Post: 29-11-2010, 04:52 PM
Bookmarks