Quote Originally Posted by 1albobs View Post
Not 100% sure really but perhaps the parallel cable or the wiring or something else!!! I've tried so much over the past few days, it's hard to tell!!! The most important thing is it's running again, so we can continue cutting orders for our customers.
Spoke too soon!!! The following issue is now occurring:-
Start program and the machine cuts for approx. 30 seconds. It then stops and the E-Stop lights up on Mach3. A page then pops up saying something along the lines of 'automatically toggle switches to on/off position'. I click on that then reset the E-Stop on Mach3 and no motors move but the XYZ counters continue to move but the router stays in a fixed position. Getting very frustrated with this now. :/
Any ides please fellas??
Regards,
Alan