Quote Originally Posted by m.marino View Post
What control software are you wanting to use? LinuxCNC, Mach3, Mach4, or something a bit different.

MACH3

Also DIYCNC out of the UK have some good boards that have a very good track history. Down side is shipping for you.

Surprisingly the shipping from UK is good, I will defiantly check them out, Thanks

Going the cheap route will bite in what you get out in production. Your electronics are one of the more important parts, as that is where your resolution and accuracy as far as steps and movement start.

Go to cheap on that end and you end up paying for it until replaced and it is not a road to go down.

I'm picking up what you're putting down :)

Michael

Thanks Michael.