Change of PC and now X and Y axis are not doing anything

[Neeps]

I have got all of the folders etc from the old system. I did copy the XML file into the new install. I thought that contained all the relevant settings. That was one of the reasons I was beginning to suspect the driver. Thanks for the screen shot. Yes my settings are and were the same (on the copied profile). I still have the old hard drive from the old HP and backups on Dropbox of the old installation., again, another reason why I'm suspecting something odd on a mixture of the driver and a dell optiplex 740.

[magicniner]

5V Parallel port????
A lot of newer ones aren't and the unbuffered RoutOut BOB will not help by boosting the signal to the driver boards.