Hello from Reading

**Clive S** · 17-05-2015

Sgreven Ok as have been mentioned and I have used one of these http://www.zappautomation.co.uk/mx36...Xb4aAiAQ8P8HAQ would greatly improve your machine it is a driver and bob all in one box with spindle control as well. or you could just buy a simple bob from ebay to get it working.. what power supply volts is it run on now? ..Clive

**sgreven** · 17-05-2015

Hi Clive, the power supply is a 36v power supply. This certainly seems like a promising solution, willl this work well with mach3?

**Clive S** · 17-05-2015

Originally Posted by sgreven

Hi Clive, the power supply is a 36v power supply. This certainly seems like a promising solution, willl this work well with mach3?

Yes it will and its a doddle to set up. it will also take a higher voltage power supply which also should be a big advantage depending on what motors you have. .. Clive