Black Cat 3020 CNC not cutting square problem

[Fivetide]

Always best to have a square machine, but if you're still out after days of tweaking and you're able to measure the discrepancies, you might consider software correction:

http://korovievskitchen.blogspot.co....on-in-emc.html

That link's for EMC (Linux CNC) - I imagine that there's also a way to achieve this in Mach.

Once again, there's no substitute for a mechanically accurate, well set-up machine, but if you're only able to make ham-fisted adjustments that aren't working for you, then this might be an option.

Wal.

That was my plan B but I might actually do as a plan A instead, I can actually compensate for it in AutoCad...thanks

[Fivetide]

Bashed it straight, did a test, top male and bottom female with a -0.25 offset , fit was perfect.. sledge Hammer ftw !

[Clive S]

Do you have a vid of the system you used ..Clive