-
24-05-2015 #1
Hi,
which motor exactly is good to make a single Y axis with long belt and exchange 2x 3Nm nema 23 motors?
I couldn't find that discussed. Asking cause i want to know the right substitute and driver, plus at what voltage? Say i want all in one multi axis like the leadshine MX366 / bit low on the voltage/ or free one CSMIO/IP-M port
i browsed the cnc4you and zappautomation and was looking at the Nema 34 8,7Nm and 12.5Nm, their inductances around 6 , where the cnc4you 12Nm motor has lower inductance of 5.1 . But the went to cncrouterparts and their nema 34 motor has inductance 2mh which is way down. Its interesting it has 100mm body.
So what are the practical solution here? Assuming <60kg gantry
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Connecting BOB one axis to 2 stepper drivers
By Noplace in forum General ElectronicsReplies: 8Last Post: 10-02-2015, 11:56 AM -
WANTED: 2 nema 23's 76mm long dual shafts 6.35mm plus one 56mm long nema 23 dual shafgt 6.35
By nobby in forum Items WantedReplies: 0Last Post: 24-09-2014, 09:57 AM -
Axis random freezing with SS=2H044MA stepper drivers??
By gerrymoore in forum Motor Drivers & ControllersReplies: 7Last Post: 01-09-2013, 09:12 AM -
Upgraded leadscrew now stepper stalls on Z axis. What are my options?
By BigAl in forum Stepper & Servo MotorsReplies: 2Last Post: 22-11-2011, 01:01 PM -
FOR SALE: 4 Axis TB6560 Stepper Motor Driver Board
By Mad Professor in forum Items For SaleReplies: 1Last Post: 04-01-2011, 06:54 PM
Bookmarks