Quote Originally Posted by Tom Aylwin View Post
Apart from my first post regarding the over-travel message I'm not sure what you need to know.

As it happens I did do a fresh air cut with the same outcome.
The first time when doing a proper cut it aborted but didn't dive into the work. Feed rate was running at 'half' speed.
Second time - the air cut - I ran at full speed (not sure why!); it did the same "Machine error - machine requested to move to x=123...blah" and aborted but this time also dived into the work before coming to a stop.
Is that any help?
Also.... might it be the computer not keeping up?. The machine stalled on pretty flat part of the job so assume the computer wasnt being overloaded but mybe I'm being naive!