Sieg KX1 & Mach3 won't come out of emergency reset

[lateAtNight]

No diagram unfortunately... would probably be in Chinese if there was! Haven't looked on the inside of the machine except for the spindle head (which is where the estop button is located). I am going to take out the multi meter and check if there is continuity on the circuit... should have done it in the first place.

I did contact Arc in the end even though they don't offer support for the machines themselves... its through another website, but long story short Arc did get back to me very quickly and assured me that someone who knows their stuff will be in contact today or tomorrow to try and sort out the problem. Fingers crossed...

[Edit] Ooops, stand corrected, there is a diagram in the manual!