Thread: CNC Lightsaber Project
-
04-06-2015 #1
Hi All,
After showing the emerging 4th axis on my build log, I figured the continuation of the Lightsaber build should go here, as it would be off topic for that thread. New vid shows my shoddy lathe skills on my Sieg SC4 and I'm dead chuffed with the 4 jaw chuck on the tailstock and dial gauge combo (given the expertise on the forum I'll go get my welding gear on for flame protection ;) ):
Also link to the first vid in case anyone missed it:
https://www.youtube.com/watch?v=H5t3Vv0bmQg
More as I get the time to work on it.......
-
06-06-2015 #2
-
06-06-2015 #3
The way he is removing the swarf with his hands is not recommended. I did that once and ended up nearly cutting the end of my finger off with a length of swarf being pulled out of my hand.
Last time i did that.Visit Us: www.automationshop.co.uk
-
The Following 2 Users Say Thank You to Gary For This Useful Post:
-
16-03-2016 #4
Hi All,
Been months since I got any time on the lathe to work on the lightsaber project, but now finally a couple of videos.
This one shows more health and safety infringements on the lathe (amongst some other nasties like trying to remember how to do threading):
and this one I'm hoping gets me some way off of the watch list for cruelty to cutters ;)
My CNC Projects: https://www.youtube.com/imadethisoncnc
-
17-05-2016 #5
Hi all,
More shoddy lathe work in the next part of the Light Saber saga (going to have to do something about my steady rest):
My CNC Projects: https://www.youtube.com/imadethisoncnc
-
17-05-2016 #6
What will you use for a power source?
You think that's too expensive? You're not a Model Engineer are you? :D
-
17-05-2016 #7
Probably a small LiPo of some kind (3.7v single cell) although there is room for some of the thinner but higher capacity batteries I use for airsoft. Also depends on the circuit board and whether that has LiPo low voltage protection etc.
My CNC Projects: https://www.youtube.com/imadethisoncnc
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Hi all! New to CNC first project 8x4 machine!
By toby in forum New Member IntroductionsReplies: 0Last Post: 10-05-2015, 11:44 AM -
Homemade CNC Project Help
By chaslam07 in forum Gantry/Router Machines & BuildingReplies: 1Last Post: 04-04-2012, 11:53 AM -
RFQ: Small CNC Project
By flipflop in forum Projects, Jobs & RequestsReplies: 1Last Post: 20-09-2011, 10:41 PM -
Wiring Project
By Karl in forum Electronic Project BuildingReplies: 2Last Post: 07-07-2011, 02:11 PM -
Project IceMould.
By NC-Joey in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 11-08-2007, 07:00 PM
Bookmarks