dual drive x-axis?

[John S]

Here you are then Hemsworthlad, job oppertunity for you, no excuse now.

Kip, loads of John S's on the zone

.

[John S]

Never gave any excuses or need any bud. . . . . . . I Wouldnt rip another blokes idea off just like wouldnt waste good money on that!! . . . . . . . . Mdf is cheap as chips and a few bits of bearings and metal shouldnt cost that much money.
I know the blokes put a bit of work into design but Cmon £728.00 for a 2 sheets of Mdf and £50.00 quids wuff of bits n bobs. . . . . . . Thats a rippoff
and it,s not like it,s a unique design or owt is it. . . . . . Like Kip said its. . Old as the Noah.:nope:

Most routers are, I have seen loads and although some have a unique part the total design is very similar.

Drive systems is where most differ, screw, ballscrew, rack, timing belt etc.

.