Denford Triac VMC with ATC Conversion / Fix

**JAZZCNC** · 22-06-2015

Originally Posted by Chaz

I tried to get Z to PID tune but its not happy and the mill starts to move the other axis without me asking. Odd. Not sure if I am getting some cross talk on the wires, ive checked all the wires a few times.

Have you tried Reversing the Encoder signal in the Plug-in.? This would cause false movement of Z axis but not sure it would affect others but possible so worth trying.!

**Chaz** · 22-06-2015

Originally Posted by JAZZCNC

Have you tried Reversing the Encoder signal in the Plug-in.? This would cause false movement of Z axis but not sure it would affect others but possible so worth trying.!

Ill try again this week. I need a new 24V PSU first. So both X and Y are reversed, otherwise they do not respond properly. Might be that Z needs to be set to normal, perhaps an assumption that they would all be the same.

**JAZZCNC** · 22-06-2015

Originally Posted by Chaz

Ill try again this week. I need a new 24V PSU first. So both X and Y are reversed, otherwise they do not respond properly. Might be that Z needs to be set to normal, perhaps an assumption that they would all be the same.

Erm fatal.!!. . . Assume Nothing.!! . . . But yes I'd have done the same. . Lol