Denford Triac VMC with ATC Conversion / Fix

[JAZZCNC]

Thanks. Considering the mill was working before, the drives should be setup correctly. The 'output' from the drive is as if it was an encoder. The drive takes the resolver input and converts it to encoder type for the controller.

Yes agreed but you'll still need to tune the Controller for position so use the IP-A Autotune and tweak settings if motors are twitchy etc..

I have a question too around cabling whilst I try and find out what could cause any funny issues.

I am using Cat 5 cable for the encoder and ref signals. So, its shielded, its 8 core + the outer core.

The drawings I have show that the -10 to +10V run in their own shield. Currently I am sharing this common cable for - 10 to + 10 plus the encoder feedback. Is this a problem? I dont mind splitting them but dont want to buy cable I dont need.

Thanks

Yes I'd separate them.

Also make sure your Grounding is correct and all Shields going to Star Ground point.!