Denford Triac VMC with ATC Conversion / Fix

[JAZZCNC]

Thanks, as suspected.

I think I have the encoder details from the manual for the drives but not the rest, will need to try and work it out somehow. Are these values entered into Mach 3 or the CS Labs unit?

It's entered into Mach3 Motor tuning in the Steps per setup. Your encoder probably be 1024ppr and quadrature so 1024x4,
So steps per Calc will be 4096 x (Any Ratio) / (Pitch) . . . . . .Ie 4096 x 2 (2:1 ratio) / 2.5mm pitch = 3276.8 Steps per Unit

Also you'll probably need tune the Position/ Vff PID settings in the Controller for best performance. Provided the Velocity PID settings are setup correctly in the Drives them selfs then the Cslabs Auto PID tuning will most likely take care of this for you. It's in the Plug-in Config.!!

ADVISE YOU RTFM BEFORE doing this.!!!