Hi, so update time. Mostly there now, busy wiring in the DC Drive input isolator. I just want to check, some of the wiring a bit uncertain about.

This is the board I am using, as recommended by i2i.

http://diycnc.co.uk/spindleV5x.pdf


On the board, I need to provide 24V DC, straight forward, I take from my 24V PSU rails.


I then need to provide the 0-10V output to the old DC drive, check, 2 wires, sorted.


I then need to provide GND, STEP, DIR and Run / Enable.


From my CS Labs unit IP-A, I get an Analog Output.


So, looking at the image below, I take from pin 7 (Analog Out 0) and pin 20 (Gnd) - do these go to the GND and STEP inputs on the board?










What do I use for DIR And Run / Enable then? Are these from my CS Labs unit (24V switched outputs)?