Panel finished...



Mesh below the slats...



Bit busy up that end of the shop



Stuck the monitor on the wall, seemed a good place, still working on the keyboard and mouse/trackball, might be a slide-out under the front of the table. I couldn't fit the PC into the main cabinet - not enough space



One odd thing I noticed when motion testing with the proper PC, the X & Z axis worked perfectly but the Y & A needed the "step active low" setting reversing in ports & pins? They sounded very rough and notchy when set the same as the other axes.

This seemed odd as all drives are the same, wired the same and connected to the same BOB????

Any ideas why I need to run two axes reversed signal level???