Second CNC table build, here we go again....

[Lee Roberts]

Looking sweet Dave, nice bit of metal work there!

[Davek0974]

Thanks,

another slow day today, had a few orders to make then fitted the cable tracks and trunking and started planning out the bed support frame.

[Davek0974]

had a couple of hours today, fitted the last of the limit switches and started on the slat support frame.

I thought a seperate frame would be best to avoid putting any heat into the side frames and make replacement easy.

50 40 x 5mm angle fitted into bed opening and a strip fitted to its bottom edge to support the slats vertically.



Quite disappointingly when i did the heavy tacks to secure the bottom return strips, the angle warped and is now 4mm high in the middle

Not good, not sure what to do about it - ignore it and let the THC tackle it, maybe slit the angles vertically in two or three places, press it flat and weld up or something else.

I didn't think angle that heavy would warp!

Apart from that it s all going to plan

[Davek0974]

Slat bed fitted at last, total PITA




Not 100% happy with it as the 50x3mm strip i ordered is a range of anything between 48x3 and 52x3 !
Will be changing it some time soon i think.

I also fixed the warped slat rails very nicely -



A quick slice with a 2mm disc and weld-up, now it sits perfectly flat on the side beams

The vertical weld was also my first vertical-up weld as i'm normally a bench top welder, didn't come out too bad i thought

Stripped it all for paint now, hopefully the weather will be good tomorrow.

[Davek0974]

Feeling a bit blue today...

Gantry...



Main frame...



Had to repaint the side beams as i forgot to fit the dust shields for the HiWin rails, probably not too important as the blocks have hard scrapers and extra seals fitted on all ends

Now to start rebuilding and final fitting.

[Davek0974]

Extract tray / chamber arrived today...



Quality is excellent, glad i outsourced this part