had a couple of hours today, fitted the last of the limit switches and started on the slat support frame.

I thought a seperate frame would be best to avoid putting any heat into the side frames and make replacement easy.

50 40 x 5mm angle fitted into bed opening and a strip fitted to its bottom edge to support the slats vertically.



Quite disappointingly when i did the heavy tacks to secure the bottom return strips, the angle warped and is now 4mm high in the middle

Not good, not sure what to do about it - ignore it and let the THC tackle it, maybe slit the angles vertically in two or three places, press it flat and weld up or something else.

I didn't think angle that heavy would warp!

Apart from that it s all going to plan