I wouldn't know a piece of Maple if you hit me with it
Tempting..:heehee:

Kip,
You only need to get the stator wound, the rotor is just an alloy and iron lamination.
You can even get standard motors rewound from 2 pole 3,000 rpm at 50 hz to 12,000 rpm at 200 hz without then going pear shaped.

You need to work on the spindle as regards tool holding etc and front bearings but it can be done.

Just a teaser
How, where and how much????
No problem with bearings and tool holder as I'm going to use dedicated spindle with ER32 collet chuck and then just use different motors to drive it