Hello All

I have just cut the new square section to go into the y axis to expand the surface area for the z to travel along and hopefully be putting that in this week and get rid of a few gremlins there.
I have tried it out and it works in virtual mode but doesn't seem to know where it is in real mode...have been doing a lot of research in this department on the net and think it is the relationship between homing and machine co-ordinates but will fiddle with that once the y axis is complete and i have eliminated them few problems there first.
The perske spindle is a monster and it rips through wood like butter but obviously no good if i cant control it.

Kingcreaky, thanks for the reply and you mentioned reducing the x axis....is this a solution only if my steppers and the controls havent got a good enough resolution?

It does go very slow to extremely fast depending on the settings.

This is my first build and i am learning enormous amounts which believe it or not, i am enjoying.

Pictures to follow as i will have to reduce the size.

Cheers for now Tommy