Well i think that's it for now...i have tried it out and it works but the top rail slightly binds or stops and occasionally shakes...if i tune the motors to different speeds/feeds it does stop but i think the linear bearings are too close together and the Z axis is too high/big for the bearing position, so i will be putting another square section between the two already there.
Hopefully this will make it have a larger surface area to run along if you know what i mean...
There is a water table going in for plasma and i have just bought a 3.3hp perske spindle for routing etc. Pictures to follow.
I also have a few videos of it working and will post them if it helps explain the problems mentioned here...
So hopefully i will have some feedback on my design whether it be praise, upgrades, alterations or criticism.
Cheers for now Tommy