Arc movement issue

[komatias]

Should not be to hard to figure out.

How did you generate the GCode? By hand? If so then you may have made a typo in the radius G2/G3. If you used a CAD program it may be that the original trace is incorrect. Check them first

[lukecnc2012]

thank you for the reply i generated the program via Cam,Ive just had a look and the arc in the cam is fine so will have another test run to see if it happens again.I am currently having a lot of issues with accuracy and loosing 0.2 in X axis when its not in rapid movements.