-
12-08-2015 #1
I am looking for help finding some information about a Sirel DC motor driver
It is from a 1997 boxford VMC 300 which I am refitting with a modern electronics and control and want to use it in the new set up if possible.
The motor appears to be a Parker DC servo motor without an encoder but there is a encoder/tac on the spindle its self.
I was wondering if anyone has any experience with this motor or drive and has any information about it because I cant find anything! I contacted boxford but they said that it has been so long since they sold it they no longer have any information
thanks
Joe
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
GEC Gemini spindle drive from Boxford 260 VMC
By Roadrunna in forum Boxford Vertical MillsReplies: 21Last Post: 21-09-2021, 12:14 AM -
Motor and Drive selection
By Marlin in forum Motor Drivers & ControllersReplies: 3Last Post: 14-08-2014, 03:25 PM -
AC servo motor to replace a 3 phase induction motor on a mill spindle.
By rnr107 in forum Spindles & Drive MotorsReplies: 2Last Post: 23-04-2014, 03:14 PM -
dc motor - spindle / shaft drive
By dsc in forum Spindles & Drive MotorsReplies: 21Last Post: 01-06-2013, 10:42 AM -
DC motor drive circuit?
By Tenson in forum General ElectronicsReplies: 4Last Post: 02-02-2012, 10:32 PM
Bookmarks