Quote Originally Posted by andy_con View Post
yeah so square up on the table using a test dial.

clamp

drill some holes

remove and fix down to a jig

put back in mill and re-square using test dial

machine the rest.

or put straight onto a vacuum table and do the whole thing in one go
No no your making it far more complex than needed. If one off then just have base board you can screw into. Clamp it down do the first op which is drilling cycle then stick a few screws into it. Remove clamps and carry on with rest of the cycle.

If got lots of same to do then do the same but with permantent fixture jig with toggle clamps and holes already in to accept threaded bolts.

Standard stuff really and not complicated or timely.!