Vacuum table Setup Advice

[JAZZCNC]

Not sure why that would take for ever and certainly doesn't need a vacuum table. Those panels would take minutes using conventional hold down methods.!
Couple of intial clamps until few holes drilled then screw it down and carry on. Simplizzzz

[andy_con]

yeah so square up on the table using a test dial.

clamp

drill some holes

remove and fix down to a jig

put back in mill and re-square using test dial

machine the rest.

or put straight onto a vacuum table and do the whole thing in one go

[JAZZCNC]

yeah so square up on the table using a test dial.

clamp

drill some holes

remove and fix down to a jig

put back in mill and re-square using test dial

machine the rest.

or put straight onto a vacuum table and do the whole thing in one go

No no your making it far more complex than needed. If one off then just have base board you can screw into. Clamp it down do the first op which is drilling cycle then stick a few screws into it. Remove clamps and carry on with rest of the cycle.

If got lots of same to do then do the same but with permantent fixture jig with toggle clamps and holes already in to accept threaded bolts.

Standard stuff really and not complicated or timely.!

[andy_con]

meh still not as good as a vacuum table ;-)

[JAZZCNC]

meh still not as good as a vacuum table ;-)

Well all can say then is you got too much bloody money. .

[andy_con]

haha if only...

I like to do thing properly first time, sometimes DIY just isn't good enough.

ive got a tormach touch probe, z height setter, tapmatic tapping heads, threadmills the lot. I like to just do it properly

[Neale]

DIY vacuum might be a bit more tricky, but I don't see how an expensive high quality vacuum system overcomes the biggest resetting issue which you have already mentioned in passing. What's all this nonsense about clocking each piece? Clamp down the spoil board, then use the router to drill holes for locating pins. You'll surely do something like this with a vacuum hold-down? After that, it's difficult to believe that toggle clamps are much slower than vacuum. The difference in cost could go to some really nice cutters, which might even reduce the cutting time by more than the difference in clamping time!

[JAZZCNC]

haha if only...

I like to do thing properly first time, sometimes DIY just isn't good enough.

ive got a tormach touch probe, z height setter, tapmatic tapping heads, threadmills the lot. I like to just do it properly

Ye I know what you mean but this isn't DIY technique it's the way it's often done in industry. Vacuum isn't widely used for small parts and those with lots of thru holes and thats for a good reason.! . . . It's very very expensive to do correctly and can be unreliable. Fixtures and Jigs work and are repeatable time after time..!! . . . Like this.!!

How well do you think your standard vacuum system would do with holding this down with so many cuts and a deep depth of cut.?