Aah that sounds much better! As I mentioned earlier I will route mostly hardwood. Oak for the most part!
I will go the "standard" way with raised x-rails from the steel frame. Epoxy leveled. Then use a 160x80 Ali profile with 8mm slots for the gantry.

Im going to have the gantrysides watercut from 10mm steel, or is it better with 20mm Ali?

The Z plate will be 20mm Ali but Im thinking about using 10mm steel for the y-car sounds good?

Grinding howls
The Madman

Skickat från min D6603 via Tapatalk