Hi from Lincolnshire

[Lee Roberts]

Hi James welcome to the forum!

5 axis has got my attention, allot go with a 4th but don't think I've seen a 5 on here yet!, good luck with the build and hope to see your progress on this.

.Me

[phoenix]

Hi Lee,

i will keep you informed or the design, still deciding which is the best way to go with the additional axis. My mind is saying go with b + c on the x axis

so my build plan will have to be a standard 3 axis cnc router, followed by it milling its own B and C axis, i can then swap out the spindle holder and wire up the additional axis.

Hopefully this will keep the cost down a little, but the over all working size of the device i would like to be 1m x 1m x .5m, so fairly large working area.

Have Fun

James