Quote Originally Posted by CheekieMonkies
I have my drivers and power supply now mate, i must say your log looks good i'm still looking through it now as i right this. I will be looking for the "ex-telecom's PSU's" on ebay though, so these would be a good choice for my drivers then?

i'v got a switched mode laptop psu that mike from routoutcnc (got his drivers) says will do ok, he dose say that there not the best choice.

Speak to you soon.

As you don't stipulate the voltage and current requirements of your drive/motor setup it's difficult to say if these power supplies would be any better for you than the "laptop" PSU you plan on using. Also you need to bear in mind that I bought my components more than 18 months ago.. so it's unlikely that you will find the same PSU still available.

If the supplier of your hardware has suggested the PSU in the pic then I would have to bow to his superior knowledge of your particular hardware. If you are looking for an alternative then it will need to comply with the hardware requirements. The PSU's I used actually output 42v unregulated at a current of 9 Amps....

hope this helps